DcW
Mid-Carder
Joined on: Dec 12, 2012 2:52:01 GMT -5
Posts: 137
|
Post by DcW on Feb 8, 2013 4:46:15 GMT -5
has any one had a problem with the overhead raw logo it does not sit square into the support and pops out all the time has anybody else had this trouble and if so how did they fix it (its like the two end supports are not straight)
|
|
|
|
Post by onleeone643 on Feb 8, 2013 5:45:45 GMT -5
Maybe you just have a defective one, return it.
|
|
JuiceWinslow
Main Eventer
Flair Country
Joined on: Sept 9, 2012 17:32:08 GMT -5
Posts: 2,706
|
Post by JuiceWinslow on Feb 8, 2013 8:46:13 GMT -5
Mine is pretty much the same way. I don't think it's defective, I think it's just made weird. It's supposed to have a curve to it...
|
|
DcW
Mid-Carder
Joined on: Dec 12, 2012 2:52:01 GMT -5
Posts: 137
|
Post by DcW on Feb 8, 2013 9:00:00 GMT -5
are the end supports supposed to point up or down
|
|
|
|
Post by Spear Guy on Feb 8, 2013 9:04:00 GMT -5
You have to curve it and there are pegs on the bottom side of the outside ends to stick them in.
It comes with directions, correct?
|
|
Will
Main Eventer
Joined on: Jun 21, 2012 7:26:24 GMT -5
Posts: 4,132
|
Post by Will on Feb 8, 2013 9:21:12 GMT -5
You have to curve it and there are pegs on the bottom side of the outside ends to stick them in. It comes with directions, correct? Yea it does |
|
DcW
Mid-Carder
Joined on: Dec 12, 2012 2:52:01 GMT -5
Posts: 137
|
Post by DcW on Feb 8, 2013 9:47:26 GMT -5
ive fixed it the end supports were bent slightly so i bent them the other way a little and it seems to have done the trick
|
|
|
|
Post by MrPerfect25 on Feb 8, 2013 9:55:07 GMT -5
Yeah mine was like that too. I just bent the side supports a lil and the banner sits in there snug now.
|
|
